Designer – Keyhole Tool
The Keyhole tools allows keyhole slots to be configured and placed.
Designer 5, Keyhole Software
Add-On Apps
Vcarve Suite
Designer – Vcarve Suite – Conform Vector
Conform Vector makes vector geometry conform to any rastered surface.
Drawing Suite
Designer – Drawing Suite – Smart Spline
The Smart Spline tool allows you to quickly define a shape by placing points, or vertexes, along a path, while on-the-fly designating the segments between as either lines or curves.
Drawing Suite
Designer – Drawing Suite – Trim Tool
The trim tool allow you to trim paths between selected vector geometry.
Drawing Suite
Designer – Drawing Suite – Offset Path
Offset Path allows you to create a path offset at a specific distance from any vector geometry.
Drawing Suite
Designer – Drawing Suite – Copy Array
Copy Array allows you to create multiple copies of an item in both the horizontal and vertical directions.
Vcarve Suite
Designer – Vcarve Suite – Centerline Text
The Centerline Text feature adds an additional Rout Mode in the Text Tool feature. This feature uses the 60° and 90° V-groove bits to follow the center of the letters for a clean engraved, v-cut look. The depth of the centerline is determined by the width of the text selected.
Modeling Suite
Designer – Modeling Suite – Extrude
The Extrude tool allows a profile to be extruded along the inside of a closed vector shape. The angle of the extrusion can be adjusted by setting horizontal, vertical, or setting a custom angle.
Modeling Suite
Designer – Modeling Suite – Sweeps
The Sweep tools will allow a drawn profile to be swept along a single vector path. This means the profile will follow the line along it’s entire length. There are two types of sweeps, rounded, which will round corners, and corner, which leaves sharp corners.
Modeling Suite
Designer – Modeling Suite – Tilt Tool
The Tilt Tool, available in the Modeling Suite, allows a pattern to be tilted vertically, horizontally, or a combination of both can be used to achieve different angles.