Find a printable version of this in the RAVEN User’s Manual The AccuTouch process ensures accurate indexing of your board edges for the most accurate project positioning. This process will appear between the board positioning and load bit screen where it asks for the actual bit. Load Bit The RAVEN then moves the cutting head […]
Category: RAVEN
RAVEN Project Setup
Find a printable version of this in the RAVEN User’s Manual A project is a set of related design elements (patterns or figures) created with the Designer software and transferred via the USB drive. These projects are accessed from the keypad under the Projects Menu. Browse the projects by using the UP-DOWN ARROWS, and press […]
Inserting a Board Into RAVEN
Find a printable version of this in the RAVEN User’s Manual Proper installation of the workpiece is critical to the performance and continued operation of the machine. To properly insert a workpiece:
Using Jigs With RAVEN
Find a printable version of this in the RAVEN User’s Manual A jig is a carrier for holding your workpiece as it is transported through the machine. Jigs can come in many different configurations, but we will cover some basics in this section. Why Would I Use A Carving Jig? A carving jig is used […]
Navigating RAVEN’s LCD Menus
Find a printable version of this in the RAVEN User’s Manual For input and display of information the RAVEN machine employs a tactile keypad and LCD display. The layout of the keypad is shown below. Use the keypad arrows to navigate the menu structure. Browse the top menu by using the LEFT-RIGHT ARROWS to scroll […]
RAVEN AccuTrack Tape and Belt
The workpiece (board) will need to be prepared before inserting it into the RAVEN machine. There are two ways to prepare a board. Apply the AccuTrack Tape and Belt The AccuTrack tape is a flexible and resilient double stick tape used for securing the Accutrack belt to the tracking edge of a workpiece. The tracking […]
Designer 5 Project Setup
Glossary Creating a New Project When creating a project, Designer will automatically detect what machines are registered to your account. It will only allow a project to be created for those types of machines. For example, if there is only A, B, or C models CarveWright machines registered, it will NOT allow the user to […]
RAVEN Project Compile Process
This document is being updated regularly. View Document
Bit Builder Tool
The Bit Builder gives users the ability to add new or custom configure existing bits. This will allow for ultimate control over all the speed, feed, and spindle settings for every bit. Custom bits can be stored globally in your system or are stored on a project level. This means if someone designs a project […]