This error is replaced by the “Calibration Range Error” message during user calibration if a number that is too big is input. Make sure to follow the direction for user calibration precisely.
During the user “Sensor” calibration, the board cut/edge test failed to perform within its tolerances. The machine is told to cut a small (0.050″ or so) slice from the notches it puts in the board with the 3/8″ bit. The board sensor re-reads the slice and checks if the machine cut the proper amount. If
For support use the contact form, or call 713-473-6572 and leave a message. Our support staff will respond within one business day.
© CarveWright | All rights reserved
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.
Site Created by Elevantics