This error occurs only during the initial homing and measurement routine before the carving. It occurs when STOP is pressed during “Check Tracking Roller” error message. This error is shown because of out of limit numbers when measuring the length of the board.
Articles Tagged: error
E48 – Waiting on Motion While Servoing Disabled
Motion was requested in software when the X/Y/Z servos were disabled. The machine will report “motion flush w/o servo”, then throw error E48 to the screen when the user presses a key. Cycle the machine power and retry the project. If the error persists, record the seven digit error code and contact CarveWright customer support.
E47 – Probe Detected
Cycle the machine power and retry the project. If the error persists, record the seven digit error code and contact CarveWright customer support.
E46 – Attempting to Call Pure Virtual Method
Cycle the machine power and retry the project. If the error persists, record the seven digit error code and contact CarveWright customer support.
E45 – Settings Value Out of Range
This error is replaced by the “Calibration Range Error” message during user calibration if a number that is too big is input. Make sure to follow the direction for user calibration precisely.
E44 – User Calibration Failure
During the user “Sensor” calibration, the board cut/edge test failed to perform within its tolerances. The machine is told to cut a small (0.050″ or so) slice from the notches it puts in the board with the 3/8″ bit. The board sensor re-reads the slice and checks if the machine cut the proper amount. If […]
E34 – Back Roller Fault
While searching for the back edge of the board, the machine is waiting for the back roller to release and then activate the board sensor to find the edge. The “Back Roller Fault” occurs when the front roller releases before the back roller indicating that the back roller is actually stuck. Go to the “Stuck […]
E33 – Front Roller Fault
While searching for the front edge of the board, the machine is waiting for the front roller to release and then activate the board sensor to find the edge. The “Front Roller Fault” occurs when the back roller releases before the front roller indicating that the front roller is actually stuck. Go to the “Stuck […]
E32 – Tracking Sensor Fault
This error occurs only during the initial homing and measurement routine before the carving. It occurs when the measured backlash on the X–drive is too large or movement was not detected. It most likely occurs when there is an issue with the board that causes tracking problems. Go to the “Possible Board Problem” message section […]
E17 – Board Find Range
This error message occurs when STOP is pressed when user is told to set the sliding plate properly.