The rollers that hold down the board have switches that alert the machine when a board is under them. If dust is preventing these switches from engaging, the machine will think there is no board. These easy steps show you how to keep them clean and clear to perform their task. DOWNLOADABLE PDF INSTRUCTIONS Checking […]
Articles Tagged: stuck
Stuck Compression Roller Message
Description of Issue During operation machine can report that one of the two sprung loaded compression rollers is stuck. This occurs when the sensors that monitor the compressed/released state of the roller is reporting an unexpected state. See a detailed description of this mechanism in the Troubleshooting section of the CarveWright Operator’s manual. Possible Causes […]
LCD Always Shows “CarveWright Woodworking Machine”
Description of Issue When the machine is turned on, the LCD screen does not progress to the Main Menu and is stuck showing “CarveWright Woodworking Machine”. Possible Causes Cause include: a corrupted memory card or a faulty controller board. Troubleshooting Steps Take the memory card to the programmer and open the Designer software. In the […]