Tracking

A/B/C Model Error Codes

E49 – Tracking Roller Failed

This error occurs only during the initial homing and measurement routine before the carving.  It occurs when STOP is pressed during “Check Tracking Roller” error message.  This error is shown because of out of limit numbers when measuring the length of the board.

A/B/C Model Error Codes

E32 – Tracking Sensor Fault

This error occurs only during the initial homing and measurement routine before the carving.  It occurs when the measured backlash on the X–drive is too large or movement was not detected.  It most likely occurs when there is an issue with the board that causes tracking problems.  Go to the “Possible Board Problem” message section

Scroll to Top