CarveWright STL Slicer Software Tutorial #1: Importing Relief Patterns
The STL Slicer software gives the user the ability to import 3d models and slice them up for carving.
STL Slicer
A/B/C Board Feeding Or Sandpaper Belt Problems
X Gears Broken or Striped
Description of Issue Broken or stripped X drive gears will be evident when the board stops moving through the machine when it is commanded. Usually, this stoppage will be accompanied by a grating noise from the X- gear enclosure on the right side of the machine. Once the gears are broken or stripped they will
STL Slicer
CarveWright STL Slicer Software Tutorial #2: Slicing Deep Relief Patterns
The STL Slicer software gives the user the ability to import 3d models and slice them up for carving.
Drawing Suite, Modeling Suite
CarveWright Software Tutorials – Modeling a Pattern 1
This video explores how the Vector Drawing Suite and 3D Pattern Modeling Suite work together to model patterns. This tutorial demonstrates the Sweep, Revolve, and Puffing tools from the 3D suite and the Smart Spline, Offset Path, and Copy Offset tools from the Vector suite
A/B/C Maintenance and Repair Instructions
Tightening the clear cover pins
Tightening the hinge pins on the clear cover to ensure good contact with the cover switches
A/B/C Maintenance and Repair Instructions, RAVEN Maintenance
Tensioning the Y belt
Tensioning the Y belt
A/B/C Cleaning, A/B/C Head Pressure, A/B/C Head Will Not Raise/Lower
Cleaning and lubricating the corner posts and lead screws
Cleaning and lubrication of the corner posts and lead screws is essential to the machine’s operation. Be sure to check your head pressure and follow thee steps regularly.
A/B/C Cleaning, A/B/C Maintenance and Repair Instructions, RAVEN Maintenance
Cleaning and lubricating the idler pulleys
Cleaning and lubricating the idler pulleys is an important part of your machine’s maintenance.
A/B/C Maintenance and Repair Instructions, A/B/C Problem With Cut Motor Or Flexshaft
Lubricating the flexshaft
Check & Lubricate Flexshaft Core The Flexshaft temperature should never rise to the point where the sheath cannot be held by hand for an extended period of time. If the sheath ever becomes hot to the touch, immediately stop the machine and consult the Lubrication section below. If the heating persists after lubrication please contact
A/B/C Cleaning
Cleaning and lubricating the bitplate
When your bit plate is sticking, its most likely dirty. These quick steps will get it moving freely again.