Board Tracking Sensor – Replacement
Board Tracking Sensor – Replacement (PDF)
A/B/C Board Feeding Or Sandpaper Belt Problems, A/B/C Maintenance & Repair
A/B/C Maintenance & Repair
A/B/C Maintenance and Repair Instructions
Board Sensor – Replacement
Board Sensor – Replacement (PDF)
A/B/C Maintenance and Repair Instructions
Replacement – AC Cut Motor Control Electronics Board (X-Termination Board)
AC Cut Motor Control Electronics Board (X-Termination Board) – Replacement (PDF)
A/B/C Maintenance and Repair Instructions
AC Cut Motor – Test & Replace
AC Cut Motor – Test & Replace (PDF)
A/B/C Maintenance and Repair Instructions
Replace Z-Truck
DOWNLOADABLE PDF INSTRUCTIONS See the CarveTight Installation Video to see the same process in a video.
A/B/C Maintenance and Repair Instructions
Re-calibrate Machine
DOWNLOADABLE PDF INSTRUCTIONS User Calibration Instructions (PDF) Calibrating the Machine Offsets The “Calibrate Offsets” function allows the user to fine tune the machine’s calibration settings for best tracking and measuring performance. There are three calibration settings that can be changed by the user: the X axis (in and out direction), the Y axis (side-to-side
A/B/C Head Pressure, A/B/C Head Will Not Raise/Lower
Head Will Not Raise Up
Description of Issue The head fails to raise-up when using the crank. Possible Causes Causes include: the red locking lever is engaged, the head is raised to the top of travel, the crank handle is not engaging, the head is not level, or there is damage to the cranking mechanism. Troubleshooting Steps Check that the
A/B/C Head Pressure, A/B/C Head Will Not Raise/Lower
Head Will Not Lower
Description of Issue The head fails to lower when using the crank. Usually it sits in place and the crank clutch continues to click. Possible Causes Causes include: the red locking lever is engaged, the head is raised to the top of travel and stuck, the lowering mechanism needs lubrication, the crank handle is not
A/B/C Maintenance and Repair Instructions
Tightening the clear cover pins
Tightening the hinge pins on the clear cover to ensure good contact with the cover switches
A/B/C Maintenance and Repair Instructions, RAVEN Maintenance
Tensioning the Y belt
Tensioning the Y belt