This error is replaced by the “Calibration Range Error” message during user calibration if a number that is too big is input. Make sure to follow the direction for user calibration precisely.
During the user “Sensor” calibration, the board cut/edge test failed to perform within its tolerances. The machine is told to cut a small (0.050″ or so) slice from the notches it puts in the board with the 3/8″ bit. The board sensor re-reads the slice and checks if the machine cut the proper amount. If
This error message occurs when STOP is pressed when prompting to check the cut motor.
While searching for the back edge of the board, the machine is waiting for the back roller to release and then activate the board sensor to find the edge. The “Back Roller Fault” occurs when the front roller releases before the back roller indicating that the back roller is actually stuck. Go to the “Stuck
While searching for the front edge of the board, the machine is waiting for the front roller to release and then activate the board sensor to find the edge. The “Front Roller Fault” occurs when the back roller releases before the front roller indicating that the front roller is actually stuck. Go to the “Stuck
This error occurs only during the initial homing and measurement routine before the carving. It occurs when the measured backlash on the X–drive is too large or movement was not detected. It most likely occurs when there is an issue with the board that causes tracking problems. Go to the “Possible Board Problem” message section
This error message occurs when STOP is pressed when user is told to set the sliding plate properly.
Bit selection part of the project data is corrupted. Format the memory card and reload the project.
If cut motor is activated while a probe is inserted, or when it is activated when cut motor is not enabled. Remove probe when doing a project.
This error message occurs when STOP is pressed when asked to reload the bit.
For support use the contact form, or call 713-473-6572 and leave a message. Our support staff will respond within one business day.
© CarveWright | All rights reserved
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.
Site Created by Elevantics