Removing The Power Supply (A, B, or C models)
Maintenance video describing the steps for removing a pre-CX style power supply. Power Supply Electronics Board – Replacement (PDF)
A/B/C Maintenance and Repair Instructions
A/B/C Model
A/B/C Model LCD Messages
Please Close Cover Message
Description of Issue The “Please Close Cover” message appears once the project begins even though the cover is closed. The machine has two switches that check to see that the cover is down before cutting. The left one reports the cover state to the electronics and the right one connects the power circuit to the
A/B/C Model LCD Messages
Error Loading Size: 28 Message
Description of Issue The machine will tend to show this error message during the beginning process or starting a carving when it cannot access the memory card data. Possible Causes The machine displays this error message when the project on the memory card has been corrupted. It improperly loads the incorrect project size, resulting in
A/B/C Model LCD Messages
Please Clear Board Sensor Message
Description of Issue This error appears when the sensor used to find the edges of the workpiece is not seeing reading within its operational limits. The sensor system consists of an infrared LED and an infrared detector. The board sensor works by reflecting infrared light off of the board and reading the intensity of the
A/B/C Maintenance and Repair Instructions, PURCHASING & SHIPPING
Properly Packing The Controller For Shipping
When returning a controller board for warranty or repair, pack it properly to help avoid shipping damage. This video walks through preparing and packaging the board for the trip back.
A/B/C Maintenance and Repair Instructions, RAVEN Maintenance
Replacing The Y Timing Belt
Maintenance video describing the steps for replacing a Y-Belt.
A/B/C Model LCD Messages
Edge Detection Failure Message
Description of Issue The edge detect failure occurs when the board sensor gets bad data when looking for a board edge during the initial measuring and homing part of the project. Possible Causes Causes include: a low board sensor reading, a very dark color workpiece, sawdust on the sliding plate, a hole in the board,
A/B/C Maintenance & Repair
Suggested Maintenance Schedule
The CarveWright is a precision machine tool. With proper care and maintenance it will provide long, reliable service. Below are regular maintenance guides and instructions on how to properly care for your CarveWright. WARNING: Always unplug machine before attempting any troubleshooting or maintenance on the machine. REGULAR MAINTENANCE Dust Removal The CarveWright is designed to
A/B/C Model LCD Messages
Check Cut Motor
Description of Issue The machine can report a Check Cut Motor message when the sensors are not reading the expected cut motor RPM. This cut motor message can be disregarded if the user desires. The motor will run without the sensor feedback but may run fast. Possible Causes Causes include: a cut motor that is
A/B/C Model LCD Messages
Board Too Thick to Cut
Description of Issue The “Board Too Thick to Cut” message appears on the LCD screen when the machine measures the inserted board thickness and determines that it is thicker than the cutting bit can cut all the way through. This message will only appear if there is a cutting operation in the project. Possible Causes