E09 – Homing Fault
Cycle the machine power and retry the project. If the error persists, record the seven digit error code and contact CarveWright customer support.
A/B/C Model Error Codes
A/B/C Model
A/B/C Model Error Codes
E06 – Z-Axis Stall
Description of Issue A Z-axis stall is caused when the difference between the commanded distance becomes much more than the actual distance over the allotted time interval. An easy example of this would be putting your hand on the cutting truck and preventing it from moving during an operation. The computer is commanding it (and
A/B/C Model Error Codes
E05 – Y-Axis Stall
Description of Issue A Y-axis stall is caused when the difference between the commanded distance becomes much more than the actual distance over the allotted time interval. An easy example of this would be putting your hand on the cutting truck and preventing it from moving during an operation. The computer is commanding it (and
A/B/C Model Error Codes
E04 – X-Axis Stall
Description of Issue An “X-Axis Stall” will happen when the machine is not able to move the board in and out of the machine when commanded. Possible Causes An “X-Axis Stall” can result from excessive head pressure, rolled up sandpaper belts, a wedged board, a board that has a significant thickness taper to it, a
A/B/C Model Error Codes
E03
Board edge detection failure (Normal) This error is shown when STOP is pressed after the “Clear Board Sensor” message is displayed. See the “Clear Board Sensor” troubleshooting section for more details. The “Clear Board Sensor” error occurs during the length (or X) edge find. After the roller releases the board sensor was not able to
A/B/C Model Error Codes
E02
Exception stack fault (Never) Cycle the machine power and retry the project. If the error persists, record the seven digit error code and contact CarveWright customer support.
A/B/C Model LCD Messages
Scan Area Message Appears Instead of the Main Menu
Description of Issue The machine is turned on and the LCD screen shows “Scan Area” menu instead of the CarveWright Main menu. This menu appears because the machine thinks that the scanning probe is installed. Possible Causes Causes include: scanning probe plugged in, old firmware, or the incorrect user setting telling the machine where to
A/B/C Model LCD Messages
Random X, Y, or Z-Axis Stall Errors
Description of Issue A random x/y/z-stall is defined as a repeated stoppage during a project where the LCD shows an X-Axis Stall, Y-Axis Stall or Z-Axis Stall seemingly with no pattern. Possible Causes This issue is usually caused by an intermittent power supply voltage, an obstacle ithat is preventing movement, or a something that is
A/B/C Model LCD Messages
Random Errors Caused by Board Being Too Thin
Description of Issue There are several issues that can be caused by inserting a board that is below the .5” minimum required thickness into the machine. These errors are all associated with other problems too so sometimes it is hard to diagnose unless you check the board thickness right away. Possible Causes A thin board
A/B/C Model LCD Messages
System Error (81). Please Contact CarveWright Message.
Description of Issue At startup the machine reports this error. Possible Causes The serial number stored on the controller electronics is corrupt. Troubleshooting Steps Verify that the serial number is corrupt by turning the machine ON and navigating to the Configurations Menu from the CarveWright Main Menu by using the up/down arrows or pressing the