Replacing the controller electronics board involves removing the old board, installing the new one, and properly packing the old board for return shipping. Follow the downloadable PDF instructions below, along with the videos for each step. DOWNLOADABLE PDF INSTRUCTIONS Removing the Controller Installing the Controller Packing the Old Controller for Shipping
Cable – Replacement of 40-Pin Ribbon Cable (PDF)
Cable – Replacement of LCD Screen Cable (PDF)
Lacing the Flat Flexible Cable (FFC) (PDF)
Board Tracking Sensor – Replacement (PDF)
Board Sensor – Replacement (PDF)
AC Cut Motor Control Electronics Board (X-Termination Board) – Replacement (PDF)
AC Cut Motor – Test & Replace (PDF)
The dust devil consists of a molded ABS plastic main body which is permanently attached to the carvewright machine and a quick release extension inside the machine which directs the vacuum very close to the cutting area, covering the full width of the machine for maximum dust removal. The extension is tightly secured to the
When the CarveWright System was new, Tips & Tricks Newsletters were published on a somewhat monthly basis to assist customers in learning proper and creative uses of their system. Newer methods of training, such as videos, are now available.This collection does contain some information that is dated and no longer applicable or reflective of the