error code

A/B/C Model Error Codes

E03

Board edge detection failure (Normal) This error is shown when STOP is pressed after the “Clear Board Sensor” message is displayed.  See the “Clear Board Sensor” troubleshooting section for more details.  The “Clear Board Sensor” error occurs during the length (or X) edge find.  After the roller releases the board sensor was not able to

A/B/C Model Error Codes

E02

Exception stack fault (Never) Cycle the machine power and retry the project.  If the error persists, record the seven digit error code and contact CarveWright customer support.  

A/B/C Model LCD Messages

Check Cut Motor

Description of Issue The machine can report a Check Cut Motor message when the sensors are not reading the expected cut motor RPM.  This cut motor message can be disregarded if the user desires.  The motor will run without the sensor feedback but may run fast. Possible Causes Causes include: a cut motor that is

A/B/C Model LCD Messages

Board Too Thick to Cut

Description of Issue The “Board Too Thick to Cut” message appears on the LCD screen when the machine measures the inserted board thickness and determines that it is thicker than the cutting bit can cut all the way through.  This message will only appear if there is a cutting operation in the project. Possible Causes

Scroll to Top