Bit selection part of the project data is corrupted. Format the memory card and reload the project.
Articles Tagged: error
E14 – Cutter Arm Fault
If cut motor is activated while a probe is inserted, or when it is activated when cut motor is not enabled. Remove probe when doing a project.
E10 – No Bit Detected
This error message occurs when STOP is pressed when asked to reload the bit.
E09 – Homing Fault
Cycle the machine power and retry the project. If the error persists, record the seven digit error code and contact CarveWright customer support.
E06 – Z-Axis Stall
Description of Issue A Z-axis stall is caused when the difference between the commanded distance becomes much more than the actual distance over the allotted time interval. An easy example of this would be putting your hand on the cutting truck and preventing it from moving during an operation. The computer is commanding it (and […]
E05 – Y-Axis Stall
Description of Issue A Y-axis stall is caused when the difference between the commanded distance becomes much more than the actual distance over the allotted time interval. An easy example of this would be putting your hand on the cutting truck and preventing it from moving during an operation. The computer is commanding it (and […]
E04 – X-Axis Stall
Description of Issue An “X-Axis Stall” will happen when the machine is not able to move the board in and out of the machine when commanded. Possible Causes An “X-Axis Stall” can result from excessive head pressure, rolled up sandpaper belts, a wedged board, a board that has a significant thickness taper to it, a […]
E03
Board edge detection failure (Normal) This error is shown when STOP is pressed after the “Clear Board Sensor” message is displayed. See the “Clear Board Sensor” troubleshooting section for more details. The “Clear Board Sensor” error occurs during the length (or X) edge find. After the roller releases the board sensor was not able to […]
E02
Exception stack fault (Never) Cycle the machine power and retry the project. If the error persists, record the seven digit error code and contact CarveWright customer support.
Scan Area Message Appears Instead of the Main Menu
Description of Issue The machine is turned on and the LCD screen shows “Scan Area” menu instead of the CarveWright Main menu. This menu appears because the machine thinks that the scanning probe is installed. Possible Causes Causes include: scanning probe plugged in, old firmware, or the incorrect user setting telling the machine where to […]