AC Cut Motor – Test & Replace
AC Cut Motor – Test & Replace (PDF)
A/B/C Maintenance and Repair Instructions
A/B/C Maintenance and Repair Instructions
A/B/C Maintenance and Repair Instructions
Replace Z-Truck
DOWNLOADABLE PDF INSTRUCTIONS See the CarveTight Installation Video to see the same process in a video.
A/B/C Maintenance and Repair Instructions
Re-calibrate Machine
DOWNLOADABLE PDF INSTRUCTIONS User Calibration Instructions (PDF) Calibrating the Machine Offsets The “Calibrate Offsets” function allows the user to fine tune the machine’s calibration settings for best tracking and measuring performance. There are three calibration settings that can be changed by the user: the X axis (in and out direction), the Y axis (side-to-side
A/B/C Head Pressure, A/B/C Head Will Not Raise/Lower
Head Will Not Raise Up
Description of Issue The head fails to raise-up when using the crank. Possible Causes Causes include: the red locking lever is engaged, the head is raised to the top of travel, the crank handle is not engaging, the head is not level, or there is damage to the cranking mechanism. Troubleshooting Steps Check that the
A/B/C Head Pressure, A/B/C Head Will Not Raise/Lower
Head Will Not Lower
Description of Issue The head fails to lower when using the crank. Usually it sits in place and the crank clutch continues to click. Possible Causes Causes include: the red locking lever is engaged, the head is raised to the top of travel and stuck, the lowering mechanism needs lubrication, the crank handle is not
A/B/C Maintenance and Repair Instructions
Tightening the clear cover pins
Tightening the hinge pins on the clear cover to ensure good contact with the cover switches
A/B/C Maintenance and Repair Instructions, RAVEN Maintenance
Tensioning the Y belt
Tensioning the Y belt
A/B/C Cleaning, A/B/C Head Pressure, A/B/C Head Will Not Raise/Lower
Cleaning and lubricating the corner posts and lead screws
Cleaning and lubrication of the corner posts and lead screws is essential to the machine’s operation. Be sure to check your head pressure and follow thee steps regularly.
A/B/C Cleaning, A/B/C Maintenance and Repair Instructions, RAVEN Maintenance
Cleaning and lubricating the idler pulleys
Cleaning and lubricating the idler pulleys is an important part of your machine’s maintenance.
A/B/C Maintenance and Repair Instructions, A/B/C Problem With Cut Motor Or Flexshaft
Lubricating the flexshaft
Check & Lubricate Flexshaft Core The Flexshaft temperature should never rise to the point where the sheath cannot be held by hand for an extended period of time. If the sheath ever becomes hot to the touch, immediately stop the machine and consult the Lubrication section below. If the heating persists after lubrication please contact