Description of Issue At startup the machine reports this error. Possible Causes The serial number stored on the controller electronics is corrupt. Troubleshooting Steps Verify that the serial number is corrupt by turning the machine ON and navigating to the Configurations Menu from the CarveWright Main Menu by using the up/down arrows or pressing the […]
After several hundred hours of usage, the motors that control the machine’s motion can have parts of them wear out. These steps show how to replace the y-motor pack that controls the up and down motion of the machine. DOWNLOADABLE PDF INSTRUCTIONS Replacing the Y Motor
The rollers that hold down the board have switches that alert the machine when a board is under them. If dust is preventing these switches from engaging, the machine will think there is no board. These easy steps show you how to keep them clean and clear to perform their task. DOWNLOADABLE PDF INSTRUCTIONS Checking
The board sensor, located on the bottom of the z-truck, may get clogged with dust over time. Use these steps to check it and clean it, when necessary.
There are several maintenance instances where you may need to remove the headcover. These steps illustrate the process. Head Cover – Removal (PDF)
The sandpaper belts can tear or roll-up over time. Replacing the sandpaper belts or upgrading to the Heavy Duty rubber belts is easy to do with these steps. DOWNLOADABLE PDF INSTRUCTIONS Installation of Heavy Duty Traction Belts Or Watch This Video
Over time the carbon brushes on the cut motor will wear down and need to be replaced. This video outlines the process.
After hundreds of hours of use, or after an x-overload or board wedge situation, you may need to replace the x-gears that engage the x motor to the belt trays. This video shows how quick and simple it is to do this operation. DOWNLOADABLE PDF INSTRUCTIONS X-Drive Gears (Base Drive) – Replacement (PDF)
Description of Issue During operation machine can report that one of the two sprung loaded compression rollers is stuck. This occurs when the sensors that monitor the compressed/released state of the roller is reporting an unexpected state. See a detailed description of this mechanism in the Troubleshooting section of the CarveWright Operator’s manual. Possible Causes
Description of Issue During initial power up, the LCD screen displays the CarveWright banner and “SRAM followed by numeric characters”. It will not let you proceed from this screen. Possible Causes The cause is a defective controller board (A2065). Troubleshooting Steps Replace the controller board (A2065).