Description of Issue The head fails to lower when using the crank. Usually it sits in place and the crank clutch continues to click. Possible Causes Causes include: the red locking lever is engaged, the head is raised to the top of travel and stuck, the lowering mechanism needs lubrication, the crank handle is not […]
Description of Issue Broken or stripped X drive gears will be evident when the board stops moving through the machine when it is commanded. Usually, this stoppage will be accompanied by a grating noise from the X- gear enclosure on the right side of the machine. Once the gears are broken or stripped they will
Tightening the hinge pins on the clear cover to ensure good contact with the cover switches
Tensioning the Y belt
Cleaning and lubrication of the corner posts and lead screws is essential to the machine’s operation. Be sure to check your head pressure and follow thee steps regularly.
Cleaning and lubricating the idler pulleys is an important part of your machine’s maintenance.
Check & Lubricate Flexshaft Core The Flexshaft temperature should never rise to the point where the sheath cannot be held by hand for an extended period of time. If the sheath ever becomes hot to the touch, immediately stop the machine and consult the Lubrication section below. If the heating persists after lubrication please contact
When your bit plate is sticking, its most likely dirty. These quick steps will get it moving freely again.
Description of Issue This occurs when the machine measures differently in the length (or X) direction in seemingly similar situations. For example, you measure two similar colored and conditioned boards and the machine comes up with widely varying lengths. Possible Causes Cause can be: board defects, rolled up belt, low head pressure, damaged or missing
The guide rods/rails upon which the cutting head assembly rides need to be kept free of cutting debris. They should be wiped or blown off before carving a project, and wiped occasionally with a thin coat of light oil for lubrication. If the rails are allowed to accumulate dust and debris, the machine will halt
For support use the contact form, or call 713-473-6572 and leave a message. Our support staff will respond within one business day.
© CarveWright | All rights reserved
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.
Site Created by Elevantics