Specs: Scanning Resolution …………………………………………………………………………………… 0.005” Scanning Step Size: Best Mode …………………………………………………………………………………………. 0.010” Normal Mode …………………………………………………………………………………….. 0.020” Draft Mode ………………………………………………………………………………………… 0.040” Maximum Scanning Probe Depth: ………………………………………………………………….. 1.000” General Information All CarveWright machines along with and CompuCarve machines that have been upgraded with the A907 motor pack will need the adapter cable and clip in order to […]

Ribbon Removed on Z-truck Statement:  The ribbon can be removed from the Z-truck and then the scanning probe can be plugged in on the cover.  This is usually done to older version CompuCarve machines in order to resolve a short in that cable. Fiction:  The customer must have the A907 Z-motor update in order to […]

The connection on the Z-truck is for the older series CompuCarve machines (about 8,000 and below).   The new machines plug directly into the connector located in the left side of the cover.  New machines must have the following: Verify version 1.121 or later of the software/firmware Verify that it is attached using the Probe […]

If the machine completes the scan and yet the scan is of poor quality, it usually means that the scanning probe has an intermittent short or disconnect.  Use the Probe State sensor check menu to see if there is a bad cable connection or if there are “dead” spots when you deflect the probe tip […]

Several things need to be checked: The scanning probe is not being recognized when it is attached (See Above Scanning Probe not recognized) Scanning Probe reading intermittently (See Above Scanning Probe reading intermittently) The tip of the probe has a sharp burr on it from the factory.  Have the customer use a file or sandpaper […]

In this case the Scanning Probe is recognized by the Machine but it gets stuck in the Open position in the middle of the scan.  Have the customer check that the hole in the body allows the probe tip to move freely. This hole may need to be opened up.