Description of Issue The “Possible Board Removal” message occurs when the head is cranked up unexpectedly. Both compression roller switches would have to be showing released during the project which the machine interprets as no board being present. Possible Causes Possible causes are: the head is cranked up in the middle of the project, here […]
Description of Issue When the machine is turned on, the LCD screen does not progress to the Main Menu and is stuck showing “CarveWright Woodworking Machine”. Possible Causes Cause include: a corrupted memory card or a faulty controller board. Troubleshooting Steps Take the memory card to the programmer and open the Designer software. In the
Description of Issue The Possible Board Problem message occurs when the board tracking sensor is unable to closely track the board with respect to the commanded motion of the drive motors. Possible Causes Cause can be: board defects, rolled up belt, low head pressure, damaged or missing o-ring on the board tracking sensor, dust in
Description of Issue The “Please Set Sliding Plate” message comes up when the machine is unable to locate the sliding plate with the tip of the bit, usually when measuring the bit before doing a cut-out operation. The tip of the bit goes below the bottom plane of the board during the cut-out operation and
Maintenance video describing the steps for troubleshooting and replacing the board sensor
Description of Issue The “Please Load Board” message comes up when the machine begins to measure the board and senses that there is not a board in the machine. It checks that both compression roller sensors are reading compressed to verify that a board is loaded into the machine. Possible Causes Causes include: no board
Maintenance video describing possible reasons for a tracking error
Description of Issue The “Please Load Bit Error” message occurs during homing when the machine is unable to verify the position of the bit tip. The machine uses surfaces on the board tracking sensor (in the cutout of the strongback at the far left of the bit travel) and the swinging bit touch plate (at
Maintenance video describing the steps for aligning the corner posts. DOWNLOADABLE PDF INSTRUCTIONS Checking and Adjusting the Head Pressure (Overall head pressure doc that does not include the leveling but does include the guide rods) Leveling the Head (head leveling only) Adjust Vertical Rods (Adjusting the vertical guide rods only)
Maintenance video describing the steps for removing the x-termination board.
For support use the contact form, or call 713-473-6572 and leave a message. Our support staff will respond within one business day.
© CarveWright | All rights reserved
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.
Site Created by Elevantics