This error message occurs when STOP is pressed when user is told to set the sliding plate properly.
Category: Consolidated Error Codes
E16 – Bit Selection Error
Bit selection part of the project data is corrupted. Format the memory card and reload the project.
E14 – Cutter Arm Fault
If cut motor is activated while a probe is inserted, or when it is activated when cut motor is not enabled. Remove probe when doing a project.
E10 – No Bit Detected
This error message occurs when STOP is pressed when asked to reload the bit.
E09 – Homing Fault
Cycle the machine power and retry the project. If the error persists, record the seven digit error code and contact CarveWright customer support.
E06 – Z-Axis Stall
Description of Issue A Z-axis stall is caused when the difference between the commanded distance becomes much more than the actual distance over the allotted time interval. An easy example of this would be putting your hand on the cutting truck and preventing it from moving during an operation. The computer is commanding it (and […]
E05 – Y-Axis Stall
Description of Issue A Y-axis stall is caused when the difference between the commanded distance becomes much more than the actual distance over the allotted time interval. An easy example of this would be putting your hand on the cutting truck and preventing it from moving during an operation. The computer is commanding it (and […]
E04 – X-Axis Stall
Description of Issue An “X-Axis Stall” will happen when the machine is not able to move the board in and out of the machine when commanded. Possible Causes An “X-Axis Stall” can result from excessive head pressure, rolled up sandpaper belts, a wedged board, a board that has a significant thickness taper to it, a […]
E03
Board edge detection failure (Normal) This error is shown when STOP is pressed after the “Clear Board Sensor” message is displayed. See the “Clear Board Sensor” troubleshooting section for more details. The “Clear Board Sensor” error occurs during the length (or X) edge find. After the roller releases the board sensor was not able to […]
E02
Exception stack fault (Never) Cycle the machine power and retry the project. If the error persists, record the seven digit error code and contact CarveWright customer support.